The Road to HA

Hello all,

I'm still using a standalone SBC but going to configure it in HA mode in the upcoming weeks.

I've started to set the pri-utility-addr and sec-utility-addr on the network-interface.

I'm wondering whether this configuration might impact the service if I keep it this way till the full implementation of HA.

P.S: the @IP I've set here are routable IP and already configured at the router's side.

I'm worried that this configuration might disrupt the service, is there any issue with ARP? any loop under the hood?

Looking forward to your replies.

network-interface
    name                 M01
    sub-port-id          1012                
    ip-address           a.b.c.d
    pri-utility-addr     e.f.g.h
    sec-utility-addr     i.j.k.l