Configurator P Rule

Hello

I have configured item as "Configurator"

In one of the segment there are 4 options available.

I tried to configure P Rule but was not able to get the selected item in the WO parts list after selecting option during SO entry.

e.g. Primary Segment - RCW

Models available under this : RCW1 ,RCW2,RCW3,RCW4

I configured UDC 59/OP with all the above models from RCW1 to RCW4

When I enter a SO for the item with Line Type W with item Configurator , the selection screen populates which shows all the available models such as RCW1,RCW2,RCW3,RCW4.....If i select one of these say RCW3 then the WO gets created, after running R31410 the parts list are attached does the show the child selected item as RCW3.