Budgetary Control Analysis Report returns no data at parent node of fund parameter
Summary:
Budgetary Control Analysis Report returns no data at parent node of fund parameter
Content (required):
I am running the Budgetary Control Analysis Report and when I run this report for Fund segment All to All.... data returns as expected. So as an example it will return data as below:
Balance by Fund
Budget Balance Total Consumption Balance Funds Available Percent
EF1 10000000.00 0 100%
ST2 5000000.00 0 100%
UG0 5000000.00 0 100%
Total 20000000.00 0 100%
Now Fund UG0, UG6 and UG1 roll up into the parent node of USE. Therefore my expectation is that if I should run this same report and set the fund segment from value to 'USE' (AS THIS IS ON THE LOV) and I set the fund segment to value to 'USE' it should by rights return me amounts for UG0, UG6 and UG1 . Now as there are no amounts for UG6 and UG1 I would expect it to return amounts for UG0.