Do a show running-config that shows only not default values

Hi There,

 

I'm just up to do a lot of configuring stuff on our ACME. And it annnoys me to always get that much of output with all the default values. For most of my configuring, I just edit two or four values, but viewing the configuration always gives me output thaaaaaaaaat long.

 

So I was thinking of a possibility of executing a "sh ru" that only shows not default values. Is there currently a

possibility of doing this?

 

And another thing i was thinking of, probably everyone knows the cisco command "sh ru | i <xyz>", is there sth in the pipe of implementing such a function?