Hello NetSuite Community,
We’re running into a Purchase Order behavior issue that’s impacting “blanket spend” scenarios (services / expense-type purchases) where the total amount is known up front, but the number of vendor invoices and line quantities are not known.
Current behavior / problem
When we create a standard Purchase Order using Item lines (e.g., expense item / non-inventory item), NetSuite appears to treat the PO as fully billed/closed once the sum of billed quantities equals the ordered quantity on the PO line. This becomes a problem when we want a single PO to allow multiple Vendor Bills over time but don’t know invoice count in advance.
What we want
We want to be able to create a PO that effectively says:
- Vendor: X
- Description: “FY26 consulting” (example)
- Total spend not to exceed: $____
- Bills will come in monthly/periodically, amounts will vary
- Multiple Vendor Bills should be able to be matched/applied to the PO over time without the PO automatically closing after the first bill (or after billed qty equals ordered qty)
Current workaround (not ideal)
We’ve been forced into a workaround where we set:
- Quantity = Amount
- Rate = $1.00
…just so we can keep applying bills without exhausting quantity quickly. It works mechanically but is not clean for reporting/audit/process.
Question about Blanket Purchase Orders
Would Blanket Purchase Orders be the recommended NetSuite approach for this scenario?
If yes:
- What is the correct process flow (e.g., Blanket PO → Release POs → Vendor Bills applied to Release POs)?
- Can the system enforce a total spend cap across releases/bills?
- Are Vendor Bills ever applied directly to the Blanket PO, or only to released POs?
- Any key setup/preferences to enable (or common gotchas) for service/expense-type purchases?
If no (Blanket POs don’t fit):
- What is the best-practice alternative in NetSuite to support “amount-based blanket PO” scenarios while still allowing multiple bills and clean PO status behavior?
Any guidance (including references to specific features/preferences/workflows) would be greatly appreciated.
Thanks!
Justin